CONCRETE Products

Apply one thin layer by roller or brush onto clean and dry surface. This primer is not meant to give opacity and normally leaves brush marks.

• For concrete and plaster, wash surface with water under high pressure, let dry , then apply one thin coat of WALL PRIMER.
• If the old coating and/or its substrate have blisters or other defects then total removal must be done by mechanical means or by stripping with paint remover. On powder old coatings, apply 1 coat Clear Binder. If substrate shows presence of fungi or algae, please proceed with the following surface preparations:
• Apply fungicidal wash by roller and leave to react for 12h minimum. Rinse with high pressure water again. Brush if necessary. Once dried, apply a coat of fungicidal treatment on the surface which will be coated the same day. Apply a thin coat of Clear Binder where necessary and leave to dry for 3h minimum.Apply 1 thin coat of wall primer.