CONCRETE Products

Apply PolyCoat using Brush, Roller or Spray. See Mixing Ratio.

GALVANIZED METAL/PVC

For new galvanized iron/PVC:
Sand lightly the surface to provide better adhesion.
For weathered galvanized iron:
Use a degreaser to remove any dirt on the surface. Sand coarsely to remove rust.
Apply Polytol Rust Remover to clean the surface and rinse off with water.

CERAMIC TILE / GLASS

Rinse off with water to remove any dirt. Make sure the surface is dry and clean.

CONCRETE

The surface shall be dry and clean.
On a porous surface, apply 1 coat of PolyColor Clear Binder.
If there is a presence of fungi or algae
Apply Fungicidal Wash by roller and leave to react for 12h min. rinse with high-pressure water again. Brush if neces¬sary. Once dried, apply a coat of Fungicidal
Treatment on the surface which will be coated the same day. Apply a thin layer of PolyColor Clear Binder where necessary and leave to dry for 3h minimum.

FOR USAGE AS PRIMER

Surface sanding is recommended after the application of PolyColor Polycoat for better adherence with the topcoat.