WOOD Products

Tools:
• Short pile synthetic roller.
• Synthetic brush.
• Floor applicator pad - synthetic/microfibre.
• Floor coater.

Apply 1 or 2 coats of OLÉOFLOOR® CLASSIC depending on type of wood and foot traffic.
Facing the light and starting opposite the door so as to work towards it, apply a first even and generous coat of OLÉOFLOOR® CLASSIC.
Start at the edge then do the entire surface, working in areas of 2 m by 2 m.
Allow to dry for 4 hours depending on the ambient conditions.

• Surfaces must be dry, clean, free of dirt, grease and other surface contamination including previous coatings.
• OLÉOFLOOR® CLASSIC can only be applied to bare wood surfaces or a wood surface that was previously finished with OLÉOFLOOR® CLASSIC. ALL other finishes MUST be completely and thoroughly removed.
• Always clean meticulously with a vacuum cleaner after each sanding, including any dust traps (skirting, radiators, pipes, window sills, etc).
• Sand floor back to bare wood using the appropriate system and abrasive grades, depending on condition of surface and wood species.
• Cracks of 2 mm wide or less should be filled with LIANFLOOR®* and sanding resumed with 80 or 100 grit paper depending on the last grit used.
• Finish with finishing grade up to grit No. 120 or 150 depending on the wood species and thickness of wear layer